Antique Chanter Aluminum Mount			
				
LOA	355 mm			
				
ID "	Bell mm	Bell mm		
			
0.255	349.0	349.0	
0.240	347.5	347.0	
0.236	346.5	346.0	
0.224	345.0	344.5	
0.219	344.5	344.0	
0.212	343.5	343.0	
0.201	342.0	341.0	
0.196	341.0	341.0	
0.192	340.0	339.0	
0.188	340.0	338.5	
0.180	336.5	335.5	
0.178	336.0	333.0	
0.176	332.5	330.5	
0.168	327.5	325.0	
				
0.168	316.0	319.5		
0.176	311.0	314.0		
0.178	309.0	312.0		
0.180	305.5	309.5		
0.188	302.0	304.0		
0.192	300.5	302.0		
0.196	298.0	299.5		
0.198	295.0	301.0		
0.201	293.0	294.5		
0.208	282.0	289.0		
0.212	279.5	283.0		
0.219	274.0	277.5
0.224	268.5	269.0
0.229	259.0	261.0
0.234	256.0	260.0
0.236	251.0	258.0
0.240	250.5	251.5
0.255	237.5	240.0
0.263	228.0	231.0
0.272	220.0	223.0
0.280	209.0	211.0
0.293	197.0	201.0
0.302	187.5	188.5
0.312	174.0	176.0
0.320	164.0	166.0
0.335	145.0	148.0
0.344	134.0	136.5
0.354	117.5	119.5	
0.365	99.0	101.0	
0.377	80.0	80.1	
0.387	62.0	64.3	
0.408	25.0	29.0	
0.418	12.5	17.5	
0.428	3.0	7.5	
0.434	0.5	3.0	

	Tone Hole Data			
				
Name	OD H "	OD D "	ID "	Bell mm
Tenon	0.5871	0.5864		355
Neck	0.5623	0.5619		308.0
D'	0.6220	0.6112	0.180	256.5
C#	0.6492	0.6418	0.180	236.0
B	0.6878	0.6808	0.200	209.0
A	0.7236	0.7158	0.194	179.0
G	0.7516	0.7428	0.180	147.5
F#	0.7728	0.7585	0.200	118.0
E	0.7912	0.7793	0.194	83.0
E-	0.8352	0.8238	0.194	46.5
Bell	0.6424	0.6437		0

Tone Hole Measurements				
OD H - measured across chanter at elevation of hole center	
OD D - measured depthwise through hole but offset to elevation	
	of top edge and rotated to position above left edge of hole
Neck, bell, tenon OD's H = across and D = through depth plane of holes	
Hole "Bell mm" centerline of hole measured from bell